MiniGen - Pro Mini Signal Generator Shield

SFE BOB-11420

New product

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. 

More details

2 Items

In Stock

By buying this product you can collect up to 30 loyalty points. Your cart will total 30 loyalty points that can be converted into a voucher of Rs. 30.00.


Rs. 3,089.35 tax incl.

Add to wishlist

More info

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

10-bit DAC for good accuracy
2 frequency registers
2 phase registers
SPI Interface Driven at 40MHz
Operating Voltage: 3.3V (5V when jumper is soldered)
Documents:

Schematic
Eagle Files
Hookup Guide
Datasheet (AD8045)
Datasheet (AD9837)
GitHub (Arduino Library, Example Code, & Design Files)

Reviews

Write a review

MiniGen - Pro Mini Signal Generator Shield

MiniGen - Pro Mini Signal Generator Shield

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p.