Close filters
 
  •  
from to
1 From 2
No results were found for the filter!
NEW
Atlas Scientific Coax-Seal
Atlas Scientific Coax-Seal
• Water proof / fully submersible • Provides years of protection • Hand moldable - stays flexible at extreme temperatures • Forms easily to odd shaped connectors • Non-conductive • Non-contaminating • 1.524m x 12.7mm (60" x 0.5") • A...
₹1,209.00 *
NEW
Atlas Scientific Magnetic Probe Holder
Atlas Scientific Magnetic Probe Holder
• No assembly required • Mounts in seconds • Holds three standard size probes • Holds two PT-1000 temperature probes, or two 1/4" tubes • Padded probe holders prevent breaking • Seriously, this product is really good
₹3,629.00 *
NEW
Atlas Scientific Large Magnetic Probe Holder
Atlas Scientific Large Magnetic Probe Holder
• No assembly required • Mounts in seconds • Holds four standard size probes • Holds four PT-1000 temperature probes, or four 1/4" tubes • Holds one 1/2" tube • Padded probe holders prevent breaking • Seriously, this product is really good
₹6,049.00 *
NEW
Atlas Scientific 30 Meter BNC Extension Cable
Atlas Scientific 30 Meter BNC Extension Cable
• BNC male to BNC female • 30 meters (100') • 430 Stainless Steel • Teflon™ • RG179 cable • 75 ohm impedance • Food safe • Max Temperature Rating: 200° C • Jacket diameter: 0.100 inch +/- 0.005 • Works with all Atlas Scientific probes
₹7,259.00 *
NEW
Atlas Scientific 3 Meter BNC Extension Cable
Atlas Scientific 3 Meter BNC Extension Cable
• BNC male to BNC female • 3 meters (10') • 430 Stainless Steel • Teflon™ • RG179 cable • 75 ohm impedance • Food safe • Max Temperature Rating: 200° C • Jacket diameter: 0.100 inch +/- 0.005 • Works with all Atlas Scientific probes
₹1,869.00 *
NEW
BNC Panel Mount Kit
BNC Panel Mount Kit
BNC panel mount kit comes with : • 1x Rubber gasket (choice of color) • 1x BNC bulk head • 1x Hinged cover • 1x BNC cable (male to male) • 1x Template sticker • 2x Mounting screws • 2x Brass couplings BNC cable specs : • 15.8cm (6.25") •...
₹2,969.00 *
NEW
Basic USB to Serial Port Expander
Basic USB to Serial Port Expander
The Basic USB to Serial Converter is a very useful tool that allows you to connect your Atlas Scientific circuits to your computer. • LED’s indicate RX and TX communication • Rapid calibration and debugging • 2 different output voltages...
₹1,209.00 *
NEW
Atlas Scientific 8:1 Serial Port Expander
Atlas Scientific 8:1 Serial Port Expander
• Expand a single UART (RX/TX) serial port into 8 additional serial ports • On-board LEDs indicate which channel has been opened • Supports baud rates greater then 1M Baud • Easily connect two Serial Port Expanders together to get 16...
₹1,649.00 *
NEW
Atlas Scientific Basic EZO™ Inline Voltage Isolator
Atlas Scientific Basic EZO™ Inline Voltage...
Data input UART, I2C and SMBus Max data rate 1 MHz Output voltage 3.9V ± .07 Voltage input 3.0V − 5.0V Power saving EN pin Current consumption 5V - 15 mA 3.3V - 20 mA Circuit dimensions 13.97mm x 20.16mm (0.55" x 0.79")
₹2,859.00 *
NEW
RTD OEM Simple Development Board
RTD OEM Simple Development Board
This breakout board comes with • (2) 4.7K resistors (used for I2C pull ups) • (2) Jumper pins and jumpers • (1) BNC connector • (1) Single row of five male header pins • This board does not come with components attached. • This board...
₹1,869.00 *
NEW
Atlas Scientific EZO™ Carrier Board *non-isolated*
Atlas Scientific EZO™ Carrier Board *non-isolated*
This carrier board is a great way to connect to an Atlas Scientific circuit neatly, eliminating the need of a bread board. The Female BNC can be replaced with a terminal block (included) if needed. • Through hole soldering ( assembly...
₹1,979.00 *
NEW
Atlas Scientific Whitebox Labs Tentacle T3
Atlas Scientific Whitebox Labs Tentacle T3
• No wiring, no bread boards • No soldering necessary, comes fully assembled • Attach up to 5 EZO ™ devices. • Works with EZO-PMP ™, EZO-CO2 ™ and the EZO-RGB. • Built in electrical isolation means that sensors won’t interfere with each...
₹11,539.00 *
1 From 2
Viewed