Top seller
NEW
NFC USB Dongle NFC USB Dongle
₹3,049.00 *
NEW
NEW
mikroDrive Board mikroDrive Board
₹1,889.00 *
NEW
NEW
NEW
SmartGPS Board SmartGPS Board
₹5,209.00 *
Close filters
 
  •  
from to
No results were found for the filter!
NEW
NFC USB Dongle
NFC USB Dongle
NFC USB Dongle is an NFC Reader-Writer based on NXP’s PN7150 high-performance full NFC controller, supporting all NFC Forum modes. The USB NFC Dongle is powered through USB connector. This NFC controller supports all NFC Forum...
₹3,049.00 *
NEW
TFT PROTO 5" Capacitive
TFT PROTO 5" Capacitive
TFT PROTO 5" Capacitive carries the 800x480 RVT50AQTNWC00 TFT screen. The SSD1963 display controller drives the TFT display, with a 1215K byte buffer that supports up to 864x480 at 24bpp displays. The touchpanel is driven by a...
₹10,399.00 *
NEW
mikroDrive Board
mikroDrive Board
Board features a high-current Darlington arrays ULN2803AN suitable for interfacing between a low-level logic circuitry and multiple peripheral power loads. Typical power loads with over 260 W (350 mA x 8, 95V) may have drivers turned on...
₹1,889.00 *
NEW
EasyTEST Board
EasyTEST Board
This board helps you to double the number of pins of single IDC10 PORT header, which allows you to monitor signals using oscilloscope probes while the PORT is in operation. Board is also useful when you need to connect two boards to the...
₹629.00 *
NEW
RFid Reader Board
RFid Reader Board
RFid Reader Board is a 125KHz RF transmitter and reciever, featuring EM4095 controller chip. The reader has three main functions: energizing, demodulation and decoding. Reader can be connected to microcontrollers or PC for encoding the...
₹2,519.00 *
NEW
5V-3.3V Voltage Translator Board
5V-3.3V Voltage Translator Board
Board features two 8-bit non-inverting bus transceiver LVXC3245. All inputs and outputs are 5V tolerant. LVCC3245 is manufactured in advanced dual metal CMOS technology. This bus transceiver contains two separate supply rails that allow...
₹2,089.00 *
NEW
mikroProg to ST-Link v2 adapter
mikroProg to ST-Link v2 adapter
mikroProg to ST-Link v2 adapter allows you to connect mikroProg for STM32 programmer and hardware debugger to 20-pin male JTAG connector on your target board. Adapter is consisted of one 2x10 male header and a 2x10 female socket. It’s...
₹529.00 *
NEW
SmartGPS Board
SmartGPS Board
SmartGPS Board is a compact solution for adding GPS functionality to your device. It features popular ublox LEA-6S module, power supply circuit, USB and antenna connectors, li-polymer battery for data retention and IDC10 header for...
₹5,209.00 *
Viewed