No results were found for the filter!
Pmod ToF: Time of Flight Sensor
The Pmod ToF (Time of Flight) is a sensor that enables optical distance sensing at low power. The on-chip digital signal processor on the ISL29501 calculates the time it takes for light emitted by the ToF to travel to the target and...
Pmod PIR: Passive Infrared Motion Sensor
T he Digilent Pmod PIR is a Passive Infrared Sensor for monitoring movement at low power. With the EKMC1601111 , you can detect movement up to 5 meters away. Features: Optimized low-power modes High sensitivity center for small movements...
Pmod BLE: Bluetooth Low Energy Interface
The Digilent Pmod BLE is a powerful peripheral module meant for use with any UART enabled development board. This Pmod employs the Roving Networks RN4870 to create a fully integrated Bluetooth Low Energy interface. This chip features an...
Pmod AQS: Digital Gas Sensor for Air Quality
The Digilent Pmod AQS is a digital gas sensor for monitoring indoor air quality at low power. With the AMS CCS811 , you can detect a wide range of Volatile Organic Compounds (VOCs) using the micro-hotplate technology, enabling a highly...
Pmod MicroSD: microSD Card Slot
The Pmod MicroSD provides a microSD card slot to any board that has 3.3V logic and is pin compatible with a 12-pin Pmod port capable of SPI communication. It allows the host board to read and write to the microSD card over a SPI...
Pmod I2S2: Stereo Audio Input and Output
The Digilent Pmod I2S2 features a Cirrus CS5343 Multi-Bit Audio A/D Converter and a Cirrus CS4344 Stereo D/A Converter, each connected to 3.5mm Audio Jacks. These circuits allow a system board to transmit and receive stereo audio signals...
Pmod ESP32: Wireless Communication Module
The Pmod ESP32 provides an easy and cost effective way to add wireless communication to any host platform or project. It uses the fully certified ESP-WROOM-32 Wi-Fi + BLE + BT module from Espressif Systems. It is suitable for a wide...
Pmod CLS: Character LCD with Serial Interface
The Pmod CLS is a character LCD module driven by the Atmel ATmega48 microcontroller. With a display size of 16x2 characters, users may display any information on the screen by communicating via SPI, I 2 C, or UART. Note: There are two...
Pmod TMP3: Digital Temperature Sensor
The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...
Pmod NIC100: Network Interface Controller
The Pmod NIC100 is designed to provide a complete Ethernet interface featuring the Microchip ® ENC424J600 Stand-Alone Ethernet Controller. The ENC424J600 provides integrated MAC and PHY support, so Ethernet functionality can be added to...
Pmod IA: Impedance Analyzer
The Digilent Pmod IA provides users with a way to measure the electrical impedance of a circuit. It is powered by the Analog Devices AD5933, a high precision impedance converter system solution that combines an on-board frequency...
Pmod DHB1: Dual H-bridge
The Pmod DHB1 uses the Texas Instruments ® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals. Features: Dual H-Bridge capable of 1.5A RMS Two quadrature...
Pmod TMP3 Pmod STEP Pmod CLS Pmod R2R Pmod DA3 One Pmod OD1 Open Pmod ISNS20 20A Pmod AMP2 Audio Pmod 8LD Eight Pmod RS232 Pmod MTDS Pmod CLP Pmod Adapter Pmod HB5 Digilent PCB Pmod CMPS2 Pmod SSD Pmod MIC3 MEMS Pmod DPG1 Pmod GYRO Pmod USBUART UART Crossover Pmod AD5 Pmod PIR Pmod GPS GPS Pmod DPOT Pmod Cable Kit Pmod BTN 4 User Pmod PS2 Pmod Clip Pmod BLE Pmod DHB1 Dual Pmod OC1 Open Pmod ALS Pmod Male Right Pmod RF2 IEEE Pmod SF3 32 MB Pmod CON3 R C Pmod SD Pmod AD2 2x6-pin to Dual 6-pin MTE Cable Arty Pmod Pack 18 Pmod Cable Pmod DA1 Four Pmod AD1 Two