Smoke click

₹1,999.00 *

Prices incl. VAT plus shipping costs

Ready to ship today,
Delivery time appr. 1-3 workdays

  • MIKROE-2560
  • MIKROE-2560
Smoke click  carries the  MAX30105  high-sensitivity optical sensor for smoke... more
Product information "Smoke click"

Smoke click carries the MAX30105 high-sensitivity optical sensor for smoke detection. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target MCU over I2C interface with additional functionality provided by the INT pin on the mikroBUS™ line.

MAX30105 sensor features

The MAX30105 is an integrated particle-sensing module. It includes internal LEDs, photodetectors, optical elements, and low-noise electronics with ambient light rejection. The sensor can detect a wide variety of smoke particle sizes.

The MAX30105 also has an on-chip temperature sensor for calibrating the temperature dependence of the particle sensing subsystem. The temperature sensor has an inherent resolution 0.0625°C.

Power consumption

Power supply current in Shutdown mode is typically 0.7μA. The module can be shut down through software with zero standby current, allowing the power rails to remain powered at all times.

Building an IoT smoke detection device

Adding WiFi connectivity to your smoke detection sensor is always a good idea. You can get a message as soon as the level of smoke goes over the set threshold. For example, Smoke click and WiFi ESP click together would do that job wonderfully.

Specifications

Type Optical
Applications Smoke detection, fire alarms
MCU MAX30105 high-sensitivity optical sensor for smoke detection
Key Features Ultra-low Shutdown current (0.7μA, typ), excellent ambient rejection capability, integrated cover glass for optimal, robust performance
Interface I2C,GPIO
Input Voltage 3.3V or 5V
Compatibility mikroBUS
Click board size S (28.6 x 25.4 mm)

Pinout diagram

This table shows how the pinout on Smoke click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

NotesPinmikroBUS logo.pngPinNotes
  NC 1 AN PWM 16 NC  
  NC 2 RST INT 15 INT Active-Low Interrupt (Open-Drain).
  NC 3 CS TX 14 NC  
  NC 4 SCK RX 13 NC  
  NC 5 MISO SCL 12 SCL2 I2C Clock Input
  NC 6 MOSI SDA 11 SDA2 2C Clock Data, Bidirectional (Open-Drain)
Power supply +3.3V 7 3.3V 5V 10 +5V Power supply
Ground GND 8 GND GND 9 GND Ground

Programming

Code examples for Smoke click, written for MikroElektronika hardware and compilers are available on Libstock.

Code snippet

This snippet initializes the system and the Smoke click board, sets the module in MultiLED mode, reads and shows data on UART.

01 void main( void )
02 {
03   system_init();
04   smoke_init();
05   smoke_set_registers_default();
06
07   while ( true )
08   {
09     smoke_read_data();
10     uart_show();
11     Delay_ms( 1000 );
12   }
13 }

 

Related links to "Smoke click"
Read, write and discuss reviews... more
Customer evaluation for "Smoke click"
Write an evaluation
Evaluations will be activated after verification.
Please enter these characters in the following text field.

The fields marked with * are required.

Viewed