No results were found for the filter!
RTD click is based on MAX31865 resistance to digital converter from Maxim Integrated , optimized for platinum resistance temperature detectors, or RTD. The click uses the PT100 type platinum probe for temperature measurement. There are...
Thermo J click
Thermo J click is a temperature measurement click board™, which uses a thermocouple type-J probe, connected to a PPC-SMP-J onboard connector. The active part of the Thermo J click is MCP9600 by Microchip - a thermocouple EMF to...
DHT22 2 click
DHT22 2 click is used for measuring the environmental temperature and relative humidity. It uses the CM2322 sensor, with very accurate thermal and humidity measuring capabilities. It can use either 1-Wire or I2C protocol to communicate...
Proximity 3 click
Proximity 3 click is an intelligent proximity and light sensing device, which features the VCNL4200 sensor from Vishay - high sensitivity long distance proximity sensor (PS), ambient light sensor (ALS) and 940 nm IRED, all in one small...
Microwave click detects movement, thanks to the PD-V11 a 24GHz microwave motion sensor. The typical use for Microwave click is a proximity or motion detector in various applications and devices. The Microwave click can detect movement or...
Water Detect click
Water Detect click is used for detecting water and other electroconductive liquids. If the detection area is wet the output of Microchip's MCP606 CMOS op-amp will go positive, signaling the presence of liquid. Water Detect click can be...
Thermo 6 click
Thermo 6 click is a precise and versatile ambient temperature measurement click board™, based on the Maxim Integrated MAX31875 temperature sensor. This sensor has a great combination of features, such as wide range of temperature...
Ozone 2 click
Ozone 2 click carries an MQ131 sensor for Ozone (O 3 ). The sensor outputs an analog voltage, which is converted by the onboard MCP3551 22-bit ADC converter or it is sent to the microcontroller via AN pin on the mikroBUS™, depending on...
Angle 3 click
Angle 3 click carries the AK7451 , a magnetic rotational angle sensor. The click is designed to run on a 5V power supply. It communicates with the target microcontroller over SPI interface, with additional functionality provided by the...
Environment click measures temperature, relative humidity, pressure and VOC (Volatile Organic compounds gases). The click carries the BME680 environmental sensor from Bosch. Environment click is designed to run on a 3.3V power supply. It...
UV 3 click
UV 3 click is an advanced ultraviolet (UV) light sensor with I2C protocol interface. The click carries VEML6070 UVA light sensor designed by the CMOS process. UV 3 click runs on either 3.3V or 5V power supply. VEML6070 sensor features...
LSM6DSL click measures linear and angular velocity with six degrees of freedom. It carries the LSM6DSL high-performance 3-axis digital accelerometer and 3-axis digital gyroscope. The click is designed to run on a 3.3V power supply....
Weather click Pressure 11 Thermo 15 click Proximity 11 Accel 11 click LSM6DSL click THERMO K click Heart Rate 8 THERMO click Pedometer 3 Tilt 2 Click 10DOF click 3D HALL 5 click 6DOF IMU 2 Vacuum click Proximity 6 Vibra sense LPS22HB click Temp Hum 2 Thermo 12 click Proximity 10 3D Hall 3 Click Air quality 2 RTD click 3D Hall 7 click LIN HALL click Temp Hum 6 Pollution click Water Detect LDC1101 click Pressure 12 Alcohol click Temp-Log 2 Grid-EYE click Microwave click Spectral 2 6DOF IMU 8 LDC1000 click Temp-hum 11 LightHz click HDC1000 click Opto Encoder 2 6DOF IMU 4 DHT22 click HTU21D click Thermo 11 click